1, first look at the amplifier and audio behind, the audio line is complete; if not, we must first buy a section of the hardware store, do not have too long, otherwise it will disk up on the back.

2, the audio cable connection is easy, find a vise or scissors can also be the audio line stripping the outer surface of the rubber layer, exposed inside the copper, are generally two colors: brass and silver.

3, dial the skin, the copper wire slightly screwed a few laps to make the copper hardness stronger, and then see the power amplifier behind the red and black post, brass red column; silver then black column.

4, the other end of the audio line is also connected to the back of the sound, and some audio is the terminal type, and some more convenient, is a button, with your fingers to buckle, the line stabbed into, and then let go, the line was card Clamped, very strong.

5, two sound, then, respectively, to the line on both sides of Left and Right, that is, the left and the right of the next line.

6, power amplifier and audio connection is good, we must give the amplifier input sound source, the sound source in general use the DVD player can, if allowed, you can also use the notebook, more flexible. The connection line need to use both ends of the lotus head is the audio line two, DVD behind the OUTPUT inserted in the L and R channel output sound signal, the same in the amplifier inserted in the L and R, but note that the INPUT input. So the sound will be output from the DVD to the amplifier, and then output from the amplifier to the sound.

7, now you can open the DVD and amplifier, you should be able to hear the sound. The following is the power amplifier front panel button instructions, we can find a small word screwdriver, plug in the microphone, while talking slowly adjust the knob until the sound for their own voice, listen to their own comfortable ok.
 
Note: Use a special speaker cable to connect. Amplifier L channel (left channel) connected to the left side of the sound, R channel (right channel) received the right side of the sound on the left and right as the standard. Two audio cable "+" and "-" must be correct, otherwise the bass will be canceled off.